It was formerly my custom to have the shoes for the front feet made flat and wide on the ground surface, with a small steel calk in at the toe to prevent wear. The web of the shoe was tapered from the toe to the heel, and the fuller or crease cut deeply, so that the heads of the nails would be on a level with the surface. The inner part had a flat bearing of about half an inch in width Moncler Jacketsfor the nail to rest on, then made con¬cave, so that there would be room between it and the sole to introduce a picker, and that the sole in its descent might not be bruised.

The shoe being properly fitted, was fastened to the hoof with nails driven about the cen¬ter of the crust, the points "getting a good hold" by coming out about an Monclerinch above the shoe. The hind shoes were made narrower and lighter, with both heel and toe calks. The plan I now follow, is, to have the fore shoes swedged with a tool that leaves a rim all around the shoe of three-eighths GHD of an inch at the base, coming to a dull edge at the apex, GHD Hair Straightenerbeing Moncler Coatsabout the same depth as it is wide. The remaining part of the web Moncler Outletis concaved on the inside, and on the outside the crease is cut where the web and rim join, with an GHDinward inclination. The nails are driven from the inside of the crust in place of the middle, with a slope that will bring them out half an inch above the shoe.