快速配置TWR-K40X256

Install the Software and Tools

Install the P&E Micro Kinetis Tower Toolkit to install the OSJTAG and USB-to-Serial

drivers. These can be found on the DVD under Software.

 第一步：安装软件和工具

安装 P&E Micro Kinetis Tower 工具包，安装OSJTAG和USB系列驱动程序，这些都在软件里面的DVD里。

Configure the Hardware

Install the included battery into the VBAT (RTC) battery holder. Then, plug in the included Segment LCD Tower Plug-In (TWRPI-SLCD) into the Touch/SLCD TWRPI socket. Finally, connect one end of the USB cable to the PC and the other end to the Power/OSJTAG mini-B connector on the TWR-K40X256 module.Allow the PC to automatically configure the USB drivers if needed.

 第二步：配置硬件

先把附带的电池安装在VBAT（RTC）电池盒里。然后，将Segment LCD TowerPlug-In (TWRPI-SLCD) 插入到Touch/SLCD TWRPI 插座里。最后将USB电缆的 一端与PC连接，另一端与TWR-K40X256 中的Power/OSJTAG mini-B连接器相连。如有需要，可以让电脑自动配置USB驱动。

Tilt the Board

Tilt the board side to side to see the LEDs on E1–E4 light up as it is tilted.

 第三步：倾斜板卡

将板从一边倾侧到另一边，如果E1- E4上的LED指示灯亮了，就表明已经倾斜了。

Navigate the Segment LCD

The Segment LCD will come up displaying the seconds elapsed since boot-up. Press SW4 to toggle between viewing the seconds, hours, minutes, potentiometer percent and temperature.

第四步：Segment LCD的导航

Segment LCD会显示启动的秒数，这时可按SW4来切换观看秒，小时，分钟，电位器％和温度。

 Explore Further by Conducting Lab 1:TWR-K40X256 Quick Start Demo.

 第五步：通过实验1：TWR- K40X256的快速启动演示来进一步探索。

以上中文为大泽翻译，接下来将实地操作，届时如果效果还OK ，将上视频，由于英语水平有限，翻译不当之处，还请高手指正，谢谢！

注：本系列标有【原创】的博文谢绝转载，谢谢！